Deforms a mesh following a path.
This module is to be used when you want to deform a random mesh to make it follow a path.
This module is used in example scenes 29 and 29bis.
Here is an example with a barbed wire mesh:
Set to true if you want to stretch the generated meshes to make them fit the end of the path.
Parameters from this section are used to scale the mesh
Simple mode scales by an arbitrary value, while Advanced mode uses curves.
Determines on what range the scale is applied:
Advanced scale mode only
Scale is applied starting at an offset
If enabled, the same scale is applied to both X and Y axis of the mesh's cross sections (local X and Y)
The (base) value of the scale to apply
Advanced scale mode only
A scale multiplier. It is expressed as a curve, which X axis is the Relative Distance (between 0 and 1) of a point on the path, and its Y axis is the scale multiplier