Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
curvy:documentation:controllers [2015/10/13 17:50] – Jake | documentation:controllers [2018/01/28 12:25] – [Move] _Aka_ | ||
---|---|---|---|
Line 25: | Line 25: | ||
Whether to use cached values when appropriate or not | Whether to use cached values when appropriate or not | ||
====Cross Position==== | ====Cross Position==== | ||
- | // | + | //VolumeController only.// This section defines the lateral starting position: |
- | + | ||
- | This section defines the lateral starting position | + | |
- | : | + | |
== Cross Range == | == Cross Range == | ||
Defines the range within the cross section the controller uses. The base point (the point ' | Defines the range within the cross section the controller uses. The base point (the point ' | ||
Line 54: | Line 51: | ||
==Speed== | ==Speed== | ||
The speed, using the above mode, or delta (if animated) | The speed, using the above mode, or delta (if animated) | ||
+ | <note important> | ||
==Clamping== | ==Clamping== | ||
- | Determines what to do when the source' | + | Determines what to do when the source' |
* **Clamp** - controller will stop | * **Clamp** - controller will stop | ||
* **Loop** - controller will start over at the opposite | * **Loop** - controller will start over at the opposite | ||
Line 88: | Line 86: | ||
==Ignore direction== | ==Ignore direction== | ||
If enabled, only the forward direction will be considered, even if the object is moving with negative speed. Otherwise the object will switch direction when moving backwards | If enabled, only the forward direction will be considered, even if the object is moving with negative speed. Otherwise the object will switch direction when moving backwards | ||
+ | |||
+ | < | ||
+ | |||
+ | ==Offset Angle== | ||
+ | The Angle (-180 to 180) starting from the Up vector, defining the direction to offset | ||
+ | ==Offset Radius== | ||
+ | The distance to offset | ||
+ | ==Compensate Offset== | ||
+ | If enabled, curve distance deviation will be compensated | ||
+ | |||
====Events==== | ====Events==== | ||
//(Spline Controller only)// | //(Spline Controller only)// |