Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
Next revisionBoth sides next revision
curvy:documentation:controllers [2016/06/29 16:04] – Jakedocumentation:controllers [2018/01/28 12:25] – [Move] _Aka_
Line 25: Line 25:
 Whether to use cached values when appropriate or not Whether to use cached values when appropriate or not
 ====Cross Position==== ====Cross Position====
-//VolumeController only// +//​VolumeController only.// This section defines the lateral starting position:
- +
-This section defines the lateral starting position +
-:+
 == Cross Range == == Cross Range ==
 Defines the range within the cross section the controller uses. The base point (the point '0' refers to) can be altered by using [[.:generator:modules:shapeextrusion#Shift]]. Defines the range within the cross section the controller uses. The base point (the point '0' refers to) can be altered by using [[.:generator:modules:shapeextrusion#Shift]].
Line 56: Line 53:
 <note important>Note that speed changes the movement direction **only** if it was "0" before!</note> <note important>Note that speed changes the movement direction **only** if it was "0" before!</note>
 ==Clamping== ==Clamping==
-Determines what to do when the source' end is reached:+Determines what to do when the source's end is reached:
   * **Clamp** - controller will stop   * **Clamp** - controller will stop
   * **Loop** - controller will start over at the opposite   * **Loop** - controller will start over at the opposite